Routine Maintenance - Honda HRE410 Originalbetriebsanleitung

When the grass bag becomes too full, grass collection is no longer
efficient, the sound of the mower changes and the bag is no longer
puffed up by the air from the blade.
Bag removal:
– release the switch lever (1) and wait until the blade stops;
– raise the discharge guard (2), grasp handle and remove bag (3)
while keeping it in an upright position.
1
Once cutting is finished, re-
lease the lever (1).
The motor and the blade
automatically stop on re-
leasing the lever (2).
FIRST disconnect the cable
extension from the supply
socket (2) and THEN from
the side of the lawnmowerʼs
switchgear (3). Wait for the
blade to stop before carry-
ing out any type of work on
the lawnmower.
This model is fitted with an motor thermal pro-
IMPORTANT
tection device to protect the motor when it (or the blade) shuts
down (or blocks) during operations, for whatever reason.
• Function: to prevent overheating and damage to the motor,
caused by abnormal use.
• Triggering of the protection device: when an abnormal event oc-
curs, the power supply to the motor is shut down immediately.
Procedure to follow when the protection device is triggered:
– release the switch lever;
– disconnect the extension lead;
– check what caused the blade to suddenly come to a halt (clean
the cutting guard);
– allow the machine to cool down in a cool environment (for from
30 to 60 minutes).
Precautions when starting up the machine again:
– check that the blade is able to move freely (using protective
gloves);
– check the safety conditions in the surrounding area (objects on the
lawn, persons or animals in the vicinity);
– connect the extension lead;
– enable the switch;
– if there are no abnormalities, such as unusual noises, you can now
continue your work.

6. ROUTINE MAINTENANCE

IMPORTANTE
keeping the safety level and original performance of the machine
unchanged in time. Store the lawnmower in a dry place.
1) Wear strong working gloves during any cleaning, maintenance
or adjustment operation on the machine.
2) Remove the grass debris after each cut and mud accumulated
inside the chassis to avoid their drying and thus making the
next start-up difficult.
3) Always ensure that ventilation openings are kept clear of de-
bris.
2 3
Only blades with the following codes must be used on this machine:
Blades must always be marked «
Given the product evolution, the above mentioned blade may be re-
placed in time by others, with similar interchangeable and operating
safety characteristics.
Reassemble the blade (2)
with the code facing the
ground, following the steps
indicated in the illustration.
Tighten the screws (3) with
a torque wrench set to 10-14
Nm.
Tighten the screws (4) with a torque wrench set to 6-8 Nm.
CAUTION:
If you do not have the required skills of equipment, it is recommended
to ask your Honda dealer for adjustment.
WARNING!
replaced; never try to repair it!
Regular, careful maintenance is essential for
81004396/0
».
A damaged or bent blade must always be
Breaking
A nicked part of an edge
A bended
Abrasion
Do not use forced water and avoid wetting the
motor or the electrical components.
5 EN