HOMCOM 800-139 Bedienungsanleitung Seite 10

EN
TROUBLESHOOTING
PROBLEM
< >is on.
< >is on.
The water reservoir has
water, but<
<E1>is on.
<E2>is on.
No water in the water
Separator pipe
lce cubes are thick and
are stuck in the machine.
The ice cubes are too
thin.
No ice cubes are being
produced.
POSSIBLE CAUSE
Lack of Water.
Too many ice cubes in the
basket.
Fault with the solenoid
>is on. valve.
Fault with the ambient
temperature sensor.
Fault with the ambient
temperature sensor.
The holes are blocked.
Water filter is blocked.
lce making cycle is too long
High ambient temperature.
High water temperature.
lce making cycle is too
short.
Ambient or water
temperature is too high.
Refrigerant system has a
leakage.
Refrigerant system is
blocked
SOLUTION
Turn off the unit and add
water to the <FULL> level,
and restart the unit.
Remove the ice cubes in
the basket.
Check with a qualifed
technician
The unit can still work.
Change the sensor.
The unit can still work.
Change the sensor.
Clean out each hole until
the water can flow.
Clean the water filter.
Press '-' to decrease the
time
Move the unit to a cooler
place.
The water temperature
should be 25℃(77℉)
maximum.
Press '+' to increase the
time
Ensure the ambient
temperature is lower than
30℃(86℉).Fill the tank
with cold water.
Check with a qualified
technician.
Check with a qualified
technician.
10