EN
4.The unit will stop when the 'lce Full' sign <
restart the ice making cycle.
Holding the 'ON/OFF' button for longer than five seconds during the ice making
cycle to switch to ice harvesting.
Pressing the 'ON/OFF' button will turn the unit off.
TIMER SETTING- UNIT OFF SETTING: The unit will automatically turn off once the
set timer is up.
TIMER SETTING- UNIT ON SETTING: The unit will automatically turn on once the
set timer is up.
Press the 'TlMER' button so the display shows '1H'. Press '+' or '_' to set the time.
During this process, the 'H' will flash. Five seconds after time is selected, the 'H'
will remain lit, indicating the setting is complete.
5. Draining water: Remove the water draining cap at the bottom of the unit and drain
the water, lt is best to change the water every 24 hours and clean the unit every
three days.
Automatic self-cleaning programme
Starting the self-cleaning programme: Plug in the unit, and hold the 'TIMER/CLEAN'
button on the control panel for longer than five seconds. The symbol<
rotating. lt takes approximately 20 minutes to complete one cycle and will turn off
automatically once finished.
Cancel the self-cleaning program: lt takes about 20 minutes to complete oneself-
cleaning program. When the program is over, the system will be in off-state
automatically. And also you can press the"ON/OFF" button on control panel to cancel
the self-cleaning program by force.
Warning
A. Check the water tank, filter and separator pipe is not blocked. Regularly clean
them.
B. The water temperature will affect the capacity of ice cubes made. The lower the
temperature, the larger quantity of ice cubes produced .
C. The ambient temperature will affect the capacity of ice cubes made. The lower the
temperature, the larger quantity of ice cubes produced.
D. Always use good quality water to make sure the pump work well. Bad quality water
will cause pump noise, but doesn't effect the unit working.
E. The compressor restart 3mins later if you turn off the unit.
> is on. Take out the ice cubes to
9
>will start