ZTE Blade V70 Max Kurzanleitung Seite 7

NOTE:
If two nano-SIM cards are installed, both cards can connect to the
4G, 3G, or 2G network, and either card can be used for mobile data.
Charging the Phone
Your phone's battery should have enough power for the phone to
turn on, find a signal, and make a few calls. You should fully charge
the battery as soon as possible.
WARNING!
Use only compatible chargers and USB Type-C cables. The use of
incompatible accessories could damage your phone or cause the
battery to explode.
WARNING!
To remove or replace the battery, contact an authorized service
provider or follow the repair instructions. If the phone is not properly
disassembled, it may cause personal injury and damage to the battery
and phone.
1. Connect the adapter to the charging jack.
2. Connect the charger to a standard AC power outlet.
3. Disconnect the charger when the battery is fully charged.
NOTE:
If the battery is extremely low, you may be unable to power on the
phone even when it is being charged. In this case, try again after
charging the phone for at least 20 minutes. Contact the customer
service if you still cannot power on the phone after prolonged
charging.
Powering On/Off Your Phone
Make sure the battery is charged before powering on.
•
Press and hold the Power key to turn on your phone.
•
To power off, press and hold the Power key until the power
off/restart menu appears, and then touch
6
> .