ZANKER ZKK 8021 Gebrauchsanweisung Seite 36

Fix cover (Hc) on guide (Ha) until it clips into place.
Open the appliance door and the furniture door at
90°. Insert the small square (Hb) into guide (Ha).
Put together the appliance door and the furniture
door and mark the holes as indicated in the figure.
Remove the brackets and mark a distance of 8 mm
from the outer edge of the door where the nail must
be fitted (K).
Place the small square on the guide again and fix it
with the screws supplied.
Should the lining up of the furniture door be
necessary, use the clearance of slots.
At the end of operations, it is necessary to check if
the door of the furniture closes properly.
Fix cover (Hd) on guide (Hb) until it clips into place.
36
Ha
Hc
PR33
8mm
Hb
PR167
8mm
K
Hb
PR168
Hb
Hd
PR167/1
Ha
Ha