HOMCOM 820-049 Bedienungsanleitung Seite 3

● WARNING: This heater is not equipped with a device to control the room temperature. Do not
use this heater in small rooms when they are occupied by persons not capable of leaving the
room on their own, unless constant supervision is provided.
● Regarding the instructions for replacing bulb, thanks to refer to the below paragraph of the
manual.
● Do not use this heater if it has been dropped.
● Do not use if there are visible signs of damage to the heater.
● Use this heater on a horizontal and stable surface, or fix it to the wall, as applicable.
● WARNING: Do not use this heater in small rooms when they are occupied by persons not
capable of leaving the room on their own, unless constant supervision is provided.
● WARNING: To reduce the risk of fire, keep textiles, curtains, or any other flammable material a
minimum distance of 1 m from the air outlet.
Getting Started
● Remove the appliance from the box.
● Remove any packaging from the product.
● Place the packaging inside the box and either store or dispose of safely.
Contents of Carton
● Heater.
● 1 instruction Manual.
Operation Instructions
● Caution: This heater should free from noticeable vibration when it is operating, this could cause
the bulb break down. Please turn the heater off firstly before movement, maintenance or clearing.
● The heater controls are located on the back side of the heater. Three rocker switches provide a
choice of heat settings.
● Switch 1 (l) Switchs on/off electricity supply to the heater and flame effect.
Note: This switch must be in the ON (l) position for heater to operate with or without heat.
● Switch 2 (l) Switchs on/off 600W heat output.
● Switch 3 (ll ) Switchs on/off 1200W output with switch 2.
Note: The flame effect can be operated with or without heat.
To adjust the permanent temperature:
1) Turn the thermostat clockwise to the biggest point.
2) When the room temperature goes up to be comfortable then turn the switch in an anticlockwise to
break point and keep the button position.
3) The function can keep necessary room temperature and also save energy.
Tip-over switch
lt has a tip-over switch, which will switch off the power supply when the heater tip over
accidentally.