Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3. To use powder detergent, turn the flap
up.
4. To use liquid detergent, turn the flap
down.
With the flap in the position DOWN:
• Do not use gelatinous or thick
liquid detergents.
• Do not put more liquid detergent
than the limit shown on the flap.
• Do not set the prewash phase.
• Do not set the delay start function.
5. Measure out the detergent and the fabric
conditioner.
6. Carefully close the detergent dispenser.
20
ENGLISH
Make sure that the flap does not cause a
blockage when you close the drawer.
10.5 Setting a programme
1. Turn the programme dial to select the
desired washing programme. The related
programme indicator comes on.
The indicator of the Start/Pause - Départ/
Pause button flashes.
The display shows an indicative programme
duration.
2. To change the temperature and/or the
spin speed, touch the related buttons.
3. If desired, set one or more options by
touching the related buttons. The related
indicators come on in the display and the
given information changes accordingly.
In case a selection is not possible, no
indicator comes on and an acoustic
signal sounds.
10.6 Additional information about
daily use
The ProSense load detection
The appliance detects the load in the first 30
seconds, during detection the indicator
flashes. The indicator stop flashing at the end
of load detection.In case of drum overload,
the indicator
It is possible to pause the appliance and
remove the exceeding garments. If the
laundry amount will not be reduced, the
washing programme starts anyway. About 20
minutes after the programme start, the
programme duration could be adjusted again
depending on the capacity of water
absorption of the fabrics. The ProSense
Technology is not available in programmes
with short cycles.
Starting a programme
Touch the Start/Pause - Départ/Pause button
to start the programme. The related indicator
stops flashing and stays on. The programme
starts, the door is locked. The display shows
the indicator
.
is flashing in the display:
Werbung
