GEZE TS 5000 E-ISM Montageanleitung Seite 15

TS 5000 E-ISM
6.9 Positioning the function saveguard of the integrated closing sequence control
Pull out driver as far as possible (1.).
X
X
Loosen screws of stop rod (max. ½ rotation) (2.).
X
X
Stop rod may not pass under driver.
Pull out stop rod (3.).
X
X
à Distance between edge block and stop is approx. 30 mm
Close moving leaf (4.).
X
X
Stop rod for function safeguard of the integrated closing sequence control is in position.
Open moving leaf (5.).
X
X
Tighten screws of stop rod (6.).
X
X
6. 1 0 Adjusting electrical hold-open device
Moving leaf is shown.
1.
3.
(~½ )
2.
6.
Mounting and securing
4.
4.
5.
GF
Fig.: 6.9.1
Fig.: 6.10.1
GB 7