GEZE TS 5000 E-ISM Montageanleitung Seite 13

TS 5000 E-ISM
6.4 Connecting 24 V power supply cable
Route 24 V power supply cable to supply terminal (1.).
X
X
Shorten excess cable to approx. 40 mm (2.).
X
X
Connect cable to terminal (3.).
X
X
6.5 Connecting wire cable to trigger
Suspend ball on wire cable in trigger lever (1.).
X
X
Guide wire cable into funnel (2.).
X
X
Pull out wire cable at deflection pulley
X
X
Loosen clamping screw
X
X
Push wire cable through clamping piece
X
X
Tension wire cable
X
X
Push trigger slide up to stop
X
X
Tighten clamping screw
X
X
Shorten wire cable to an excess of 30-50 mm to outer edge of guide rail
X X
6.6 Mount sliding lever to fixed leaf and connect with sliding block
Connect sliding lever with door closer (tightening torque 14 Nm) (1.).
X
X
Connect sliding lever to sliding block (tightening torque: 5 Nm) (2.).
X
X
Close fixed leaf
X
X
(3.).
(4.).
(5.).
(6.).
(7.).
(8.).
(3.)
Fig.: 6.6.1
Mounting and securing
(9.).
Fig.: 6.6.2
Fig.: 6.4.1
Fig.: 6.5.1
Fig.: 6.6.3
GB 5