Merit MLT-MB4501 Bedienungsanleitung Seite 58

LP Tank Exchange
• Many retailers that sell grills offer you the option of replacing
your empty LP tank through an exchange service. Use only
those reputable exchange companies that inspect, precision
fill, test and certify their cylinders. Exchange your tank only
for an OPD safety feature-equipped tank as described in
the "LP Tank" section of this manual.
• Always keep new and exchanged LP tanks in upright position
during use, transit or storage.
• Leak test new and exchanged LP tanks BEFORE
connecting to grill.
LP Tank Leak Test
For your safety
• Leak test must be repeated each time LP tank is exchanged
or refilled.
• Do not smoke during leak test.
• Do not use an open flame to check for gas leaks.
• Grill must be leak tested outdoors in a well-ventilated
area, away from ignition sources such as gas fired or
electrical appliances. During leak test, keep grill away
from open flames or sparks.
• Use a clean paintbrush and a 50/50 mild soap and water
solution. Brush soapy solution onto areas indicated by arrows in
figure below. Leaks are indicated by growing bubbles.
WARNING
If "growing" bubbles appear do not use or move the LP tank.
Contact an LP gas supplier or your fire department!
▲Do not use household cleaning agents. Damage to the
gas train components (valve/hose/regulator) can result.
WARNING
Only the gas type and gas category listed in rating label on the
barbecue could be used on your barbecue!
Gas hose and Gas Regulator
1. Use only regulator and hose approved for LP gas at
correct pressure.
2. The pressure adjuster shall comply with the standard EN
12864 and correct regulation in the country where it is
installed, which may be found at your nearest retailer of gas
items. Refer to the technical data, it is strictly prohibited to use
adjustable pressure.
3. The life expectancy of gas regulator is estimated as 10 years.
It is recommended that the regulator is changed within 10
years of the date of manufacture or national conditions require
it.
4. The type of replaceable hose should meet the standard of
EN 1763-1 Class 3.
5. The hose used must confirm to the relevant standard for the
country if use. The length of hose must be 0.7-1.5meters.
worn of damaged hose must be replaced. Ensure that the
hose is not obstructed, kinked, or in contact with any part of
barbecue other than as its connection. It is recommended
that the hose is changed with 1 year of the date of
manufacture or the national conduction require it.
6. During serving or installation, make sure that the
connection flexible tube is not subjected to twisting.
WARNING
The gas grill is attended to be used with regulator and hose
assembly, of they are note supplied by manufactory, the user
must choose authorized the regulator and gas hose complying
with the standard and local regulations
Only the gas type and gas category listed in rating label on the
barbecue could be used on your barbecue!
Connection to appliance
1. Before connection, ensure that there is
not debris caught in the head of the
gas cylinder, regulator. Burner and
burner parts.
2. If the hose is replaced, it must be
secured to the appliance and
regulator connection with hose clips,
disconnection the regulator from
cylinder (According to the directions
with regulator) when the barbecue is
not in use.
WARNING: only Non-Combustible
surface could be used to support
this gas appliance when the
support temperature exceeds 50 K
10