Merit MLT-MB4501 Bedienungsanleitung Seite 51

DO
*Use spanner to tighten all gas fittings
*Check all gas hose and line connection for
damage, cuts or cracks each time for using the
appliance.
*Always leak test with soapy water
*Check main burners, side burners and
infrared rear burner regularly for insect nets
such as spiders, ants, etc. Nets are dangerous
and need to be fully cleaned.
*Use the appliance outdoors only
*Accessible parts maybe very hot. Always
Keep children away from the appliance
*Have the gas cylinder filled by an authorized
gas supplier
*Always wear protective gloves when handling
hot component
*Close the gas cylinder valve after each use
*Clean the grease tray regularly.
*USE grill at least 1.5 m from any wall or
surface, combustible material, gasoline, flame
liquids or vapors
Burning off the barbecue after every use(for
approx 15 minutes) will keep excessive food
residue to a minimum.
*Turn off the gas supply at the gas cylinder
after use."
*Place the gas cylinder outside the cart for
using
*Turn off the gas supply at the cylinder in the
event of gas leak .
Do not do
*Lean over appliance when lighting
*Store combustible material, gasoline or
flammable liquids or vapors within vicinity of
barbecue
*Use appliance with any cover on
*Use plastic or glass utensils on the
Barbed se
*Use the appliance in strong winds
*Dismantle control valves
*Test for gas leaks with a naked flame
*Store spare gas cylinders in the cabinet
*Lay the gas cylinder down (always keep
upright]
*Use appliance indoors
*Modify the constructions of the appliance or
the size of any burner, injector orifice or any
other components
*Move the appliance during using
*Obstruct any ventilation of the appliance
*Allow the flexible gas supply hose or any
electrical cord to come in contact with any
heated surface of the appliance
*Use charcoal or any other solid fuel in this
appliance
*Disconnect any gas fittings while the
appliance is in using
*Use a rusty or dented gas cylinder with a
damaged gas valve
*Fill the gas cylinder beyond 80% cap
*Use the infrared rear burner at the same time
as other burners
*altere the sealed parts by end user
*modify the appliance
3