Merit MLT-MB4501 Bedienungsanleitung Seite 57

USE AND CARE
DANGER
• NEVER store a spare LP cylinder under or near
the appliance or in an enclosed area.
• Never fill a cylinder beyond 80% full.
• If the information in the two points above is
not followed exactly, a fire causing death or
serious injury may occur.
• An overfilled or improperly stored cylinder is a
hazard due to possible gas release from the
safety relief valve. This could cause an intense
fire with risk of property damage, serious injury
or death.
• If you see, smell or hear gas escaping,
immediately get away from the LP cylinder
and appliance and call your fire department.
LP Tank Removal, Transport And Storage
• Turn OFF all control knobs and LP tank valve. Turn
coupling nut counterclockwise by hand only - do not use
tools to
disconnect. Lift LP tank wire upward off of LP tank collar,
then lift LP tank up and off of support bracket. Install
safety cap onto LP tank valve. Always use cap and strap
supplied with valve.
Failure to use safety cap as directed may result in
serious personal injury and/or property damage.
LP Tank Valve
• A disconnected LP tank in storage or being transported
must have a safety cap installed (as shown). Do not store
an LP tank in enclosed spaces such as a carport, garage,
porch, covered patio or other building. Never leave an LP
tank inside a vehicle which may become overheated by
the sun.
• Do not store an LP tank in an area where children play.
LP Gas Cylinder
• The gas cylinder shall not be dropped or handled
• The precaution to be taken when changing the gad
• Cylinders must be stored on outdoors and out of
• This appliance is only suitable for use with low-
• 28-30mbar regulator with butane gas @category I3+
• 30mbar or 50mbar regulator with butane, propane or
• LP cylinder must be arranged for vapor withdrawal and
• LP Gas cylinder shall be purchased from local site and
• Gas cylinder shall be located on ventilation cylinder
• If gas cylinder was inserted with compartment, effective
• Before installation, please check nameplate on rear of the
• Make sure that all connections are gas tight by brushing
Safety Cap
Retainer Strap
NOTE: Do not obstruct or block the ventilation openings of the
container compartment of appliances.
9
roughly! If the appliance is not in use, the cylinder
must be disconnected. Replace the protective cap on
the cylinder after disconnecting the cylinder from
appliance.
cylinder which shall be carried out away from any
source of ignition.
reach of children. The cylinder never be stored where
the temperature can reach over 50C. Do not store the
cylinder near flames pilot lights or other sources of
ignition.
pressure butane, propane or their mixture gas and
fitting with appropriated low-pressure regulator via a
flexible hose.
The barbecue is set to operate.
their mixtures category I3B/P(30) or I3 category
I3B/P(50) respectively.
include collar to protect LP cylinder valve. Always keep
LP cylinders in upright position during use, transit or
storage.
matched with local national requirements, Supply gas
type and pressure required for this appliance was shown
on rating label, 9kg to 23kg LP gas cylinder shall be used
for current gas appliance. maximal external dimensions
(regulator included) shall not be more than dia. 500mm
X900mm.
compartment, Gas cylinder shall never be moved during
operation period, it shall be fixed with rigid support.
ventilation is provided by openings compartment base
and upper side areas. The total area of the openings in
the upper part being at least 1/100th of the floor area of
the compartment and that of the openings at the base
being at least 1/50th of the floor area of the compartment.
appliance to ensure the appliance is suitable for gas
supply available.
with a soapy water or liquid detergent (a gas leak will
form bubbles). If bubbles form, close cylinder valve and
hand tighten all fittings again. IF bubbles still form, do
not use stove, have a dealer check the appliance.