Timago ACTIV-TIM Benutzerhandbuch Seite 32

2. Applica�on
The wheelchair is designed for people who have problems with unassisted moving
and for pa�ents with dysfunc�ons and reduced mobility. This self-propelled
wheelchair can also be pushed by an accompanying person. The wheelchair is
suitable for indoor and outdoor use.
3. Assembly
Step 1. Unfolding the wheelchair
Place the wheelchair on the ground. Unfold the wheelchair using the armrests.
Then, press the center of the seat so that all the elements fit together.
Step 2. Backrest and seat
Li� the backrest upwards and lock it with backrest locks which are located below
the hand grips. Fix the upholstery on the wheelchair.
Step 3. Footrests
Fix the footrest on the outer side of the frame. Then turn the footrest inwards
un�l it is locked.
Step 4. Armrests
The armrests are �ltable. To raise the armrest, press the buton located on the
frame (under armrests) of the wheelchair.
Step 5. Height adjustment of footrests
Adjust the footrests using the screw located on the tube. Enough space should be
le� between the footplates and the ground as footplates set too low may cause
difficul�es in climbing hills and curbs. Adjust the footplates so that the angle
between trunk and thighs is 90
Step 6. Assembly of safety straps
Atach the safety straps to the footrests to prevent the user's legs from sliding
down the footplates.
FOLDING
The wheelchair can be re-folded in order to be transported and stored more
easily.
• Swing away the footplates and set them in ver�cal posi�on.
• Detach the upholstery.
• Use the handles to li� the seat upwards un�l the frame of the wheelchair is
folded.
(op�mum si�ng posi�on for the user).
0
32