Installation - BWT 7-810365 Einbau- Und Bedienungsanleitung

I.
II.
III.
VI.
2

Installation

Install filter according to its nominal width in cold
water pipes of the same dimensions and before
the equipment to be protected. Install stop valves
before and after the filter.
Only 3/4" und 1"
Install connecting module in the direction of flow in
the horizontal or vertical cold water pipe (observe
direction of flow arrow).
I. Turn the retaining ring to the left until it stops.
II. Push the unit's catches into the recesses
III. Rotate the unit by 45º clockwise until it stops.
IV.Pull the retaining ring with both hands towards
the unit until it locks into place. The unit is now
protected against accidental twisting.
To loosen the filter, press the retaining ring
towards the connecting module.
Only 1 1/4" - 2"
Screw the filter to the connecting piece (2) (four
fastening screws and washers supplied). Tighten
the screws evenly without undue stress.
Every size
Route the waste water connection (see page 3,
Fig. 3) with tube to the sewage channel or provide
a collection basin (capacity approx. 10 l).
Please note: The flushing water hose must be
installed at a minimum distance of 20mm to the
highest possible waste water level (free dis-
charge).
GB
13