Silvercrest SHGL 3 A1 Bedienungsanleitung Seite 9

Switch on the product by moving the on/
off switch I/0 to I position . The indicator
6 ] [
light flashes red to indicate that the
7 ] [
product is heating up .
As soon as the temperature is reached, the
indicator light lights up red continuously .
[ 7 ]
Move the lock/unlock switch
position . The product is ready for use .
Put a strand of hair approx . 5 cm above the
scalp between the upper hotplate
lower hotplate . Do not touch your scalp
8 ] [
with the product .
Close the upper hotplate
lower hotplate
[ 8 ]
between . Smoothe the hair slowly form hair
top to tail (approx . 6 to 8 seconds per hair
strand, depending on the hair type) .
If necessary, repeat the above steps until the
result is satisfactory .
After you are finished with styling or when the
product is no longer used, move the on/off
switch I/0 to 0 position immediately . The
[ 6 ]
indicator light goes off .
[ 7 ]
Remove the mains plug
socket . Allow the product to cool down
completely in a well-ventilated location .
˜ Troubleshooting
Fault
The product is not working . The mains plug
The hair does not get
straightened .
˜ Cleaning and care
m DANGER! Risk of electric shock!
Always switch off the product and disconnect
the mains plug
4 ] [
before cleaning the product .
m DANGER! Risk of burns! Do not clean
the product right after operation . Let the
product cool down first .
10 GB/IE/NI
to
[ 5 ]
and the
[ 1 ]
and the
1 ] [
with the strand of hair in
from the mains
[ 4 ]
Possible cause
connected to a mains
socket .
The mains socket is
defective .
The product is not yet
heated up .
from the mains socket
NOTES:
Keep the product out of reach of pets or
young children during or after use .
The hair must be clean, dry and free of styling
products . This excludes special products that
promote the straightening of the hair .
Comb the hair thoroughly before
straightening .
Use the product in a well-ventilated room .
˜ Off mode
NOTE: Disconnect the product from the
mains supply immediately after use . The
product is completely free of electrical power
only when unplugged .
1 . The product enters the off mode automatically
when the product is connected to the mains
supply and no button is pressed .
2 . After approx . 30 minutes switch on, the
product will switch to Off mode automatically .
The signal light goes off .
3 . To keep using the product, switch it off and
then wait for 1 second before switching it
back on .
Action
is not Connect the mains plug
4 ] [
socket .
Try a different mains socket .
Wait for a while until the product has
heated up .
m WARNING! Do not immerse the product's
electrical components in water or other
liquids . Never hold the product under running
water .
m CAUTION! Do not use corrosive or abrasive
cleaning agents or hard brushes to clean the
product .
to a mains
4 ] [