Werbung
OPERATION
•
When the switch is turned on, the buzzer sounds and the unit enters
standby mode. The WIFI icon flashes and the display shows the indoor
temperature.
•
When you press the ON/OFF button, the heating icon in the unit and the
low temperature icon will light up at the same time.
•
To change the heating cycle, press the Increase or Decrease button to
make adjustments. The unit can operate in low, high and frost protection
modes.
•
If the ambient temperature is below 5°C, the antifreeze mode is activated
and the low heat icon is displayed. When the ambient temperature is ≥ 7
°C the heating wire stops heating, the power icon goes out and only the
antifreeze icon is lit.
•
Temperature selection button: When the number is flashing, the
temperature can be adjusted. Press the increase or decrease button,
adjust and select the desired temperature within the temperature range
of 5 °C to 50 °C. When the temperature reaches the set temperature,
the unit will stop heating and when the temperature falls below the set
temperature, the unit will start working again.
•
Use the timer buttons: The display symbol lights up in white. Press the
increment or decrement key to select the desired operating time within
the range of 1 to 24 hours. The machine will stop working when the
preset time is reached.
•
Schedule time: In Standby mode, press the temperature selection button.
The timer icon will light up. Select from 1 to 24 hours and the appliance
will start when the set time is reached. The set temperature is 25°C, i.e. if
the ambient temperature is below the set temperature, the unit will start
working and if the ambient temperature is above the set temperature, the
unit will go into standby.
•
Child lock button: When you press and hold the increase button, the
child lock icon lights up. At this time, all buttons on the interface are
unavailable. When you press the Increase key again, the child lock icon
will go out, indicating that all the buttons on the interface can be used
normally again.
•
Window opening function: In all heating modes, if a window is opened
and the temperature drops by 5°C or more within 5 minutes, the product
will automatically stop heating and the white indicator in the window
open mode will light up. The window opening function icon on the display
will light up. If it is necessary to restore the heating operation, first unlock
it (if locked), then press and hold the increment and decrement buttons
for 5 seconds to return to the operating mode before opening the
window.
•
Pressing and holding the temperature selection button for 3 seconds will
access the four preset programme modes: P0/P1/P2/P3. The number
"P0" flashes on the screen. Press the increase and decrease buttons and
EN
25
Werbung
