Winix 5500-2 Kurzanleitung Seite 5

CONTROL PANEL
06 07
®
01. PlasmaWave Indicator
Indicates whether the Plasmawave
Technology is enabled or disabled.
02. Fan Speed Indicator
Indicates the current fan speed.
03. Timer Indicator
If the timer has been set, the LED light
indicates the set time of operation.
04. Change Filter Indicator
The LED light indicates when it is time to
change your replacement filter.
05. Light Sensor
Detects the amount of ambient light in the
environment. When in Auto Mode, the Light
Sensor detects when to put the unit into
Sleep Mode.
06. Power Button
Turns the unit on or off.
07. Mode Button
Press to cycle through and set the desired
mode of operation (Auto Mode, manual
settings, and the Sleep Mode).
MAINTENANCE
When to Replace Filters
Filter
Pre-Filter
Active Carbon Filter
True HEPA Filter
• Intervals between filter replacement may vary depending on environment.
• For optimal use, Pre-Filter can be cleaned once every 14 days which can extend the life of
other filters.
To purchase replacement Winix filters:
contact your local dealer.
English
01
02
09
08
08. PlasmaWave
® Press the Plasmawave
is on to enable or disable this feature.
09. Air Quality Indicator
Color coded LED light indicates one of three
levels of Air Quality: Red (poor), Amber (fair),
and Blue (good).
10. Fan Speed Button
Enables manual operation of the unit.
• Press to cycle through and set the desired
11. Timer Button
• Press to cycle through and set desired
12. Filter Reset Button
After replacing the filter, turn on the unit and
then use a thin object, such as a paper clip, to
press the Filter Reset button for 5 seconds.
13. Smart Sensor
Checks the air quality in the environment and
helps to improve it automatically.
Indicator Light When to Ser vice
Clean once every
none
Can NOT be WASHED
03 04
10 11 12
®
Button
® button when the unit
fan speed: Low Medium
length of operation: 1hr
[NO TIMER]
When to Replace
14 days
Lasts Approx.
116130
05
13
High Turbo
4hr 8hr
Permanent
12 months
H FILTER
5