Winix 5500-2 Kurzanleitung Seite 4

English
INITIAL OPERATION
1. Remove the front panel by grasping its
upper edge and gently pulling forward.
2. Press on the Pre-Filter tabs, near the top
of the filter, release and remove. Pull out
the Active Carbon Filter and True HEPA
Filter.
3. Remove filters from protective plastic
wrap.
WHERE TO USE
12~18 in 12~18 in
30 ~ 45 cm
4
Latch
4. Install the filters until they fit securely in
Tabs
Pre-Filter
5. After filters are installed, close the front
6. Insert the power cord into an electrical
Allow 30 ~ 45 cm of space between TVs, radios, and
other electronics
Electromagnetic interference from certain electronics
may cause product malfunction.
Place indoors away from direct sunlight
Direct exposure may cause product malfunction or
failure.
Only place on hard, flat surfaces
Flimsy or slanted surfaces may result in abnormal
noise and vibrations.
12~18 in 12~18 in
30 ~ 45 cm
Allow at least 30 ~ 45 cm from walls for maximum air
flow
02 03
01
place.
03. True HEPA Filter (back)
02. Active Carbon Filter (middle)
01. Pre-Filter (front)
panel.
outlet.
Latch
English