Epropulsion SPIRIT 1.0 Plus Bedienungsanleitung Seite 12

5 Operation
5.1 Checklist before Start
1. Check and ensure the battery has enough power.
2. Ensure the outboard is correctly and firmly installed on the boat.
3. Ensure the propeller is correctly and firmly installed on the outboard.
4. Ensure the battery is correctly and firmly installed on the outboard.
5. Before start, check and ensure the throttle is in zero position.
6. Ensure the throttle can travel smoothly.
7. Check the connections before each trip, ensure the connections are cor-
rect and secure, no disconnection or worn or aging connections.
8. Check and ensure the power port is dry to avoid short-circuit.
Only start the outboard when the propeller is under water.
If the cable has been immersed in water, please dry the cable thoroughly
before connection or turning on power.
5.2 Starting
Step1: Put the kill switch on the pointed position of tiller.
Figure 5-1
Step2: Attach the other end of the kill switch to your wrist or life vest.
20
Figure 5-2
For safety consideration, always attach the lanyard of kill switch to your
wrist or life vest, so that the outboard will be stopped in the emergency
situation of falling.
The kill switch has magnetic field, keep it 50cm/20inch away from pace-
makers and other medical implants.
The magnetic field of kill switch may interfere with some electronic in-
struments, keep it away from these electronic instruments.
Keep the kill switch 50cm/20inch away from magnetic cards (e.g. Credit
cards) and other magnetic media.
Step3: Press and hold (≥2secs) the "POWER" button to power on the system.
Figure 5-3
Step4: Turn the throttle form neutral position to a desired direction to start
the outboard motor. Change the heading direction of the boat by turning the
tiller on horizontal level.
21