Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1///////////////////////
PRECAUTIONS 1///////////////////////
This unit is constructed of precision electronic components and
1.
should
never
be disassembled.
2.
Do not store or use this unit in areas subject to temperature ex-
tremes or sudden temperature
3.
Do not store or use this unit near heaters or in areas subject to
direct sunlight, high humidity, or large amounts of dust.
Should any type of liquid or metallic objects ever enter into the
4.
case of this unit, immediately switch power OFF and consult with
your retailer or a nearby dealer.
Avoid plugging multiple devices into a single power outlet. Such
5.
overloading not only results in improper operation, it is also very
dangerous.
6.
Always be sure to switch power OFF when the unit is not in use.
During extended periods of non-use, unplug the AC adaptor from
the power outlet.
7.
Note that using this unit near a television or radio may cause in-
terference with normal reception.
8.
Never use thinner, benzine, or other volatile agents to clean the
exterior of this unit. Use only a soft cloth dampened with a mild
neutral detergent solution and thoroughly wrung out to remove
all excess
moisture.
9.
Only connect to this unit devices specifically named by the
manufacturer (except for commercially available tape recorders
or Centronics standard printers). The manufacturer can held no
way responsible for any damage or abnormal operation caused
by connection of non-specified devices.
10. Touching connectors with the fingers may result in improper con-
tact, and damage to internal circuitry caused by static electricity.
11. Generation of an abnormal amount of error during data record-
ing and reading may indicate a dirty tape recorder head. Clean
the tape recorder head following the procedures specified by the
recorder
manufacturer.
2
changes.
1//////////////////////
GENERAL G UIDE 1//////////////////////
REM connector
AC adaptor jack
EAR connector
PHASE switch
MIC connector
Power lamp
PRINTER switch
Power lamp
Note that the FA-80 itself does not have a power switch. Once an
fx-8000G is connected to the FA-80 and the power of the fx-8000G
is switched ON, the power lamp of the FA-80 lights and power is
supplied.
PRINTER
switch
Specifies t hetypeof printer t o be usedforprintinggraphics. T hisswitch
can be at either setting for character printout.
• MSX
MSX standard printer
Printer
connector
MODE switch
Computer connector
3
Werbung
