Lumatek CONTROL PANEL PLUS Benutzerhandbuch Seite 8

2. System Settings
To set Time and Date to your local time;
Press [0K] and then [>] to System Settings and [0K] to enter
In System Settings press [<]or[>] to Hour and
am/pm clock. Press [0K] to save.
Press [<]or[>] to Time and [A]or[v]
Press [<]or[>] to Date and
and [0K] to save.'
3. Setting Signal Protocol
I . When setting controller
Press [SET] button to select 0-1 OV analog
This will make both Zones compatible
2. When setting controller
Press [SET] button to select RS485 digital signal protocol
This will make both Zones compatible
3. When setting controller
Press [SET] button to select both 0-1 OV & RS485 signal protocols
tor lights on). This will make Zone A compatible
patible for HID electronic
4. Setting Zone Parameters
Press [0K] to enter
Press [<]or[>] to ZONE A and
Setting ballast/driver/fixture
Press [<]or[>] to Type and [A]or[v] to select ballast/driver
save.
Setting light intensity by selecting
Warning! New lamps need to run at nominal
they don't fail prematurely.
nominal power use, new HPS lamps
lamps may be dimmed.
Warning! Do not boost MH/CMH
to set time in hours and minutes and [0K] to save.
to set date in Day [D], Month
for LED drivers/fixtures;
for LED drivers.
for HID ballast/fixtures;
for HID electronic
for LED drivers/fixtures
ballasts.
Home screen
[0K] to enter
type:
power output
If using new lamp; set Power to 100%. After 100 hours
may be dimmed
lamps which must not exceed
to toggle
signal protocol (LED indicator
(LED indicator
ballasts.
and HID ballast/fixtures;
for LED drivers and Zone B com
type and Press [0K] to
level:
power for at least 100 hours to ensure
and boosted
between 24hour and
[M] and Year [Y]
light on).
light on).
( both LED indica
and MH/CMH
their nominal power.