Lumatek CONTROL PANEL PLUS Benutzerhandbuch Seite 7

Warning! The controller
remote ballasts and complete
6. Find a suitable
sensor between
against the wall. Do not position in direct airflow or light. If you are using another
climate control system, hang temp sensor close to the sensor of that system.
7. Position and affix controller
mounting loops.
8.
Connect lamp control
Zone A/B signal output socket-W-to In socket on ballast l.
9.
Connect the power input (B) and the temperature
light up and you can continue
POWER ADAPTOR
SOCKET
ZONE A THERMO
SENSOR OUTPUT
5.2 Setting up the controller
1. Function keys
RIGHT SHIFT
PAGE UP OR
PAGE DOWN
Note! Whilst keying in settings if no operation
the display will revert
may only be connected
fixtures.
place for the temperature
the plants at average
to the wall using mounting
cable (TRScable with ferrite suppression
to set up the controller.
ZONE
SENSOR
to Home screen.
to compatible
sensor and the controller.
canopy height and preferably
screws (E) through
probes (D). The display wil
ZONE A LIGHT
SIGNAL OUTPUT
B THERMO
OUTPUT
SET BUTTON
TOGGLE 0-1 OV LED
& RS485 HID
is performed within 10 seconds
Lumatek Controller
Hang the
not
the
ring) (C) from
ZONE B LIGHT
SIGNAL OUTPUT
CONTROL
INCREASE
DECREASE
PARAMETERS
0K AND
OR
SAVE