Lumatek CONTROL PANEL PLUS Benutzerhandbuch Seite 10

Press [<]or[>] to Hour and Minute settings and
minutes and [0K] to save.
Press [>] to Power setting and [A]or[v] to set power output
To pre-set switch
6. Real time On/Off
Press [0K] to enter Home screen
Press [<]or[>] to ZONE A and [0K] to enter
In ZONE A Press [<]or[>] to Power and
intensity) and Press [0K] to action
Selecting 0% will switch lamps Off.
Repeat to set up Zone B.
Note! If controller
and Time/Date will be saved.
6. CONTROLLER
LED ON: Normal status (temperature
LED OFF: Temperature
LEDSLOW FLASH: High temperature
LED FAST FLASH: High temperature
LED ON: Lamp is on
2
LED OFF: Lamp is off
The same reading as 1
7. LED FAILURE INDICATOR
Note! If controller
the event of any failure; the LED above
table below to decode
If controller connected;
flash every 2 seconds;
ballast fails to receive
cable connection
quickly (every 0.2 seconds).
highest power output setting on ballast will flash. See table below to decode
Off; set Power to 0%.
switching and adjusting
and save.
is disconnected from power supply; any set parameter
LED INDICATOR
probe is working
probe cable not connected
auto-dim threshold;
auto-shutdown;
5 0-10V LEDON only:
0-1 OV analog
to both
4 The same reading
3
ON ELECTRONIC
not connected; the power OUtPUt LED will go On normally
fault.
the 'controller
this means that the controller
signal from the controller
or controller failure) the 'controller'
In the event of any other failure; the LED above
to set time in hours and
light intensity
to select required
normally)
correctly or temperature
ballast will now dim to reduce
ballast will switch off.
signa
Zones for LED drivers
as 2
BALLAST
highest power output
' LED on electronic ballast
is working
(either because
LED on ballast will flash
and [0K] to save.
power output
values
control fail.
temperature.
RS485 LED ON only:
6
RS485 digital signal to both
Zones for HID
Both 0-10V & RS485 LED ON:
Zone A is 0 IOV for LED drivers
Zone B is RS585 for HID ballasts.
and in
setting will flash. See
will turn Onand
normally.lf the
of poor signal
fault.
(light
and