Werbung
Verfügbare Sprachen
Verfügbare Sprachen
CONDITION
Ballast
Locked
Cycle
Error
Low
Mains
Over Temperature
High Mains
Note!
To reset
ballast;
Warning! When replacing
plug from power supply. Never switch off lamp by removing
a live
ballast.
8. LUMATEK
CONTROLLER
FAULT
Controller
doesn't
have
any display
after
connecting
to power
Fail to control
ballasts
Controller
doesn't
have
any temperature
display
after the temperature
probe
is connected
Fail to turn on lamp
Ballast output
power
not same
as command
signal sent from controller
When
several
ballasts
are working
together,
some units are working
well
but
some
fail to work
LED STATUS
Flash*
1
Flash*2
Flash*3
Flash*4
Flash*5
disconnect
from
mains
a lamp, always switch Off ballast first by removing
TROUBLESHOOTING
INSPECTION
METHOD
Check
the Power Supply
Check
the Adaptor
Check
the
Controller
Check
the
connection
controller
and
make
sure
each
is well-plugged.
Check
if the temperature
probe
is damaged.
Check
'controller'
on ballast is flashing
Check
the
Sun rise and
set time periods
is
Check
the temperature
probe
& temperature
control
values
Check
control
connections
Check
if the
is fau ty
DESCRIPTION
Maximum
attempts
Lamp stopped
or output
Mains Voltage
Maximum
driver temperature
Mains Voltage
and
reconnect
TROUBLESHOOTING
Waiting
Change
Change
between
ballasts;
Reconnect
connection
LED
normally
Reset
set.
Disconnect
cable
control
ballast
indicator
amount
of ignition
without
SUCCess
for unknown
reason
signal interrupted.
too Low
exceeded
too High
after
30 seconds
lamp cable
from
for power supply to return
the Adaptor
the Controller
the
control
cables
Change
to another
temperature
probe
Reconnect
Cables
or switch
off sun rise
[set time period.
Reset temperature
control
values.
and
reconnect
cable
or replace
cable.
Check
LED failure
on ballast.
Werbung
