Lumatek CONTROL PANEL PLUS Benutzerhandbuch Seite 5

4. SAFETY GUIDELINES
Warning! Keep the controller
contamination.
Warning! The Lumatek
compatible Lumatek
controller to other products
malfunctions in the connected
Warning! Do not open or disassemble
parts. Opening the controller
Warning! Make sure the signal cables do not touch the reflectors
reflectors get very hot!
5. INSTALLING THE
5.1 Preparations
For HID:
Mount the fixtures or ballasts as per your lighting
1.
Interconnect them
using the control
Connect ballast
2.
to the In socket
Connect ballast
3.
to In socket of ballast
Connect all remaining
4.
5. Connect the ballasts
THERMO SENSOR
UP TO 200 BALLASTS
Note! Each of the controller's
200 Lumatek Control
control fixtures in two separate
away from fire, excessive heat, water, dust and
Digital Control Panel may only be used to control
controllable fixtures and ballasts. Do not connect
as this may be dangerous
equipment.
the controller,
will void the warranty.
CONTROLLER & FUNCTIONS
as described in the
cable (TRS)supplied
1 control cable from
of ballast 2.
2 control cable from
3.
ballasts in series accordingly.
or fixtures to the
POWER
INNOVATION
ZONE A
two channels
fixtures or ballasts. It is possible to use those channels
rooms or to control
and may cause
Doing so will void the warranty.
it contains
plan.
manual for the fixture
with each controllable
Out socket of ballast
Out socket of ballast
mains.
LUMATEK
L u,MATEK
ZONE B
(Zone A & Zone B) can control
up to 400 fixtures in one room.
the
no serviceable
as the
or ballast
fixture or ballast.
1
2
THERMO SENSOR
UP TO 200 BALLASTS
up to
to