Lumatek CONTROL PANEL PLUS Benutzerhandbuch Seite 6

For LED:
1. Mount the fixtures or drivers as per your lighting
them as described
signal cables and T-junction
Connect T-junctions
Connect fixture 1 control cable
2.
socket of fixture 2 T-junction.
Connect fixture 2 control cable
3.
In socket of fixture 3 T-junction.
4. Connect all remaining
Connect the drivers
5.
Note! Each of the controller's
to 50 Lumatek LED fixtures or drivers. It is possible to use those channels
fixtures in two separate
Warning! Only Each Channel
A can control the same-powered
different powered ballasts eg: Zone A can be set to control
Zone B set to control
in the manual for the fixture or ballast using control
component
to fixture Dimming
from Out socket of T-junction
from Out socket of T-junction
fixtures in series accordingly.
or fixtures to the
two channels
rooms or to control
(Zone) can only control same-powered
ballasts
600W or 315W ballasts.
plan. Interconnect
which are sold separately.
cables
mains.
FIXTURE
LED FIXTURES CONNECTED
(Zone A & Zone B) can control
up to 100 LED fixtures in one room.
as Zone B or Zone B can
600W ballasts and
1 to the In
2 to
T-JUNCTION
DIMMING CABLE
IN SERIES.
up
to control
ballasts; Zone
be set to control