Werbung
Verfügbare Sprachen
Verfügbare Sprachen
BUILDING IN THE HOB
• Check that the kitchen unit and the opening conform to the requirements in respect of measurements and ventilation.
• Remove any wood shavings after the cutting work in the worktop opening and treat the cut edges of plastic or wooden
worktops with sealing varnish if necessary to prevent the worktop from swelling due to moisture.
• Lay the hob upside down on the worktop.
• Mount the plug to the connecting cable in accordance with the imposed requirements.
• Mount the supplied fastening brackets using the supplied screws in the induction hob.
fastening bracket
• Turn the hob over and lay it in the opening.
• The bracket can be adjusted with the screw, making it suitable for different thickness worktops.
• Connect the hob to the mains supply. The hob is now ready for use.
• Check the operation. If the induction hob is connected incorrectly, it will give a sound signal or show an error code
on the displays.
REMOVING THE HOB
Disconnect the appliance from the power supply. Remove the induction hob by applying pressure from below.
Attention! Take care not to damage the appliance! Do not try to remove the induction hob by trying to lift it out of the
worktop from above.
fastening bracket
30
English
•
Werbung
