Starting The Appliance - Indesit DI 420 Installation Und Gebrauch

Starting the Appliance

Starting a wash cycle....
After performing all the operations described in the
previous paragraphs, turn the water tap on completely,
open the appliance door and press ON-OFF button "A":
indicator light "B" comes on. Your appliance is now on
and awaiting instructions.
Setting and Starting a Wash Cycle
Select the wash cycle by pressing button "P". Each time
this button is pressed, one of the indicator lights "G" will
come on in sequence, select the wash cycle you deem
most suitable for the type of dishes to wash (take a look
at page 17, where you will find the wash cycle table).
Close the appliance door and after a few seconds, you
will hear a short beep: the wash cycle has begun.
Cancelling or modifying a cycle while underway...
Premise: A cycle that is underway can only be modified
if it has only been running for a short time.
Open the appliance door carefully to avoid any hot water
splashes, then keep button "P" pressed for approximately
5 seconds, until you hear 3 short beeps. Indicator light
"G" will come off and at this point, all the settings will
have been cancelled. You are now free to re-set the correct
wash cycle.
If you forget to load some of the dishes...
Interrupt the wash cycle by opening the appliance door
with the utmost care, as usual, then insert the dish you
had forgotten. When you shut the appliance door, the
cycle will start up from where you interrupted it. restart at
the point where it left off.
EN
There's been a power failure? Have you opened the
dishwasher door?
The wash cycle stops and then restarts when the electricity
comes back on or when you close the door.
At the end of the wash cycle...
The end of the wash cycle is indicated by a double beep
and the flashing of the wash cycle indicator light "G".
Warning:
Open the dishwasher door, turn the appliance off by
pressing button “A”, unplug the appliance from the
electricity socket to cut off the power supply; the power
supply cable should consequently be easily
accessible.
Turn off the water tap.
Wait a few minutes before unloading the dishes: they are
very hot! If you wait a little while, they dry better thanks to
the steam.
Empty the lower rack first.
Make sure the wash cycle has ended before removing
the dishes!
Warning
If opening the door soon after the end of the programme,or
during it, stand away from the Dishwasher, to avoid
possible injury from hot steam.
$