Indesit DI 420 Installation Und Gebrauch Seite 23

Installation
Positioning the Appliance
Position the appliance in the desired location. The back
should rest against the wall behind it, and the sides, along
the adjacent cabinets or wall. The dishwasher is equipped
with water supply and drain hoses that can be positioned
to the right or the left to facilitate proper installation.
Levelling the Appliance
Once the appliance is positioned, adjust the feet (screwing
them in or out) to adjust the height of the dishwasher,
making it level. In any case, the appliance should not be
inclined more than 2°.
If the appliance is level, it will help ensure proper perfor-
mance.
Adjusting the Back Feet
Insert the appliance into the cutout and then adjust the
height using the screws located on the front bottom part
of the machine. Use a screwdriver to turn the screws in
the clockwise or anti-clockwise direction to increase or
decrease the height respectively.
Cold Water Connection
This electric household appliance should be connected
to the water mains using the cold water supply hose
provided with the appliance only. Do not use a different
hose. In the event of replacements, use original spare
parts only.
Connect the cold water supply hose to a 3/4 gas threaded
connection, taking care to screw it tightly onto the tap.
If the water hoses are new or have been out of use for an
extended period of time, let the water run to make sure it
is clear and free of impurities before making the
connection. If this precaution is not taken, the water inlet
could get blocked, causing damage to your dishwasher.
- It is strongly recommended to use a new hose to connect
the dishwasher to the water supply line, and the old hose-
set should not be reused. Asking to specilized shop or
an authorized service technician (see Service).
Hot Water Connection
The water supply to the appliance can also be connected
to the house's hot water line (centralised system, heating
system), as long as it does not exceed a temperature of
60°C.
In this case, the wash cycle time will be shortened by
about 15 minutes and the wash efficiency slightly reduced.
The connection must be made to the hot water line
following the same procedures as those for the connection
to the cold water line.
Anti-flooding protection
Your dishwasher is provided with a special system which
blocks the water supply in the event of leaks inside the
appliance.
EN
*
Drain Hose Connection
Fit the drain pipe into a drain
line with a minimum diameter of
4 cm or place it over the sink.
Avoid restricting or bending it.
The part of the pipe marked with
the letter A should be between
40 and 100 cm above the
ground.
The pipe should not be
immersed in water.
Electrical Connection
After making sure that the voltage and frequency values
for the current in the home correspond to those on the
rating plate (located on the stainless steel inner door of
the appliance) and that the electrical system is sized for
the maximum voltage on the rating plate, insert the plug
into an electrical socket which is earthed properly (the
earthing of the appliance is a safety requirement mandated
by law). If the electrical socket to which the appliance
must be connected is not appropriate for the plug, replace
the plug, rather than using adpators or the like as they
could cause overheating and burns.
Caution:
- Once the appliance has been installed, the electrical
plug and socket should remain accessible.
- If the power supply cable is damaged, it must be
replaced by the manufacturer or its Technical Assistance
Service in order to prevent all potential hazards. (See
Assistance)
- The cable should not be bent or compressed.
- The Company shall not be held responsible for any
incidents that occur if these regulations are not observed.
Condensation-proof tape.
On some models, a transparent condensation-proof
adhesive tape has been provided.
It should be stuck onto the lower side of your wooden
worktop to protect it from the formation of condensation.
When not provided, this tape can be requested as a spare
part from authorised retailers.
*
Only available in selected models.
A