Removing The Transportation Locks; Connecting Water Supply; Connecting To The Drain - Beko WMY 91446HLB1 Bedienungsanleitung

2.3 removing the transportation locks

A
WArNINg:
Do not remove the transportation
locks before taking out the packaging
reinforcement.
WArNINg:
Remove the transportation safety
bolts before operating the washing machine!
Otherwise, the product will be damaged.
1. Loosen all the bolts with a suitable spanner until
they rotate freely (C) .
2. Remove transportation safety bolts by turning them
gently.
3. Attach the plastic covers supplied in the User
Manual bag into the holes on the rear panel. (P)
C
Keep the transportation safety bolts in a safe place
to reuse when the washing machine needs to be
moved again in the future.
Never move the product without the transportation
safety bolts properly fixed in place!

2.4 Connecting water supply

C
The water supply pressure required to run the
product is between 1 to 10 bars (0.1 – 1 MPa). It is
necessary to have 10 – 80 liters of water flowing
from the fully open tap in one minute to have your
machine run smoothly. Attach a pressure reducing
valve if water pressure is higher.
If you are going to use the double water-inlet
product as a single
must install the supplied stopper to the hot water
valve before operating the product. (Applies for the
products supplied with a blind stopper group.)
30 / EN
(cold)
water-inlet unit, you
A
WArNINg:
Models with a single water inlet
should not be connected to the hot water tap. In
such a case the laundry will get damaged or the
product will switch to protection mode and will not
operate.
WArNINg:
Do not use old or used water inlet
hoses on the new product. It may cause stains on
your laundry.
1. Connect the special hoses supplied with the product
to the water inlets on the product. Red hose (left)
(max. 90 ºC) is for hot water inlet, blue hose (right)
(max. 25 ºC) is for cold water inlet.
A
WArNINg:
Ensure that the cold and hot water
connections are made correctly when installing the
product. Otherwise, your laundry will come out hot
at the end of the washing process and wear out.
2. Tighten all hose nuts by hand. Never use a tool
when tightening the nuts.
3. Open the taps completely after making the
hose connection to check for water leaks at the
connection points. If any leaks occur, turn off the
tap and remove the nut. Retighten the nut carefully
after checking the seal. To prevent water leakages
and damages caused by them, keep the taps closed
when the machine is not in use.

2.5 Connecting to the drain

• The end of the drain hose must be directly
connected to the wastewater drain or to the
washbasin.
A
WArNINg:
Your house will be flooded if the
hose comes out of its housing during water
discharge. Moreover, there is risk of scalding due
to high washing temperatures! To prevent such
situations and to ensure smooth water intake
and discharge of the machine, fix the end of the
discharge hose tightly so that it cannot come out.
• The hose should be attached to a height of at least
40 cm, and 100 cm at most.
• In case the hose is elevated after laying it on the
floor level or close to the ground (less than 40 cm
above the ground), water discharge becomes more
difficult and the laundry may come out excessively
wet. Therefore, follow the heights described in the
figure.
Washing Machine / User's Manual