Intended Use; Grounding Installation; Control Panel; Preparation Before Use - Arktic 271551 Bedienungsanleitung

• If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order
to avoid a hazard.
• ATTENTION! Do not fill the load over MAX
level.
• The
Cyclopentane in this appliance. It is highly
flammable.
• CAUTION! RISK OF BURNS! Refrigerant liquid
sprayed on the skin can cause critical burns.
Keep eyes and skin protected. If refrigerant
burns occur, rinse immediately with cold
water. In case burns are severe, apply ice and
contact medical treatment immediately.
• WARNING! Provide sufficient ventilation in
the surrounding structure when building-in.
Never block the air flow suction and air
outlet in order to keep air circulation.
• WARNING! Do not use mechanical devices or
other means to accelerate the defrosting
process, other than those recommended by
the manufacturer.
• WARNING! Do not damage the refrigerant
circuit.
• WARNING! Do not use electrical appliances
inside the food storage compartments of the
appliance, unless they are of the type
recommended by the manufacturer.
• Do not place any dangerous products, such
as fuel, alcohol, paint, aerosol cans with a
flammable
explosive substances, etc. inside or near the
appliance.
• Once installed, the appliance must not be
tilted at an angle greater than 5° and it is
necessary to wait 2h before connecting it to
the power supply to switch it on. The same
applies if the appliance is moved afterwards.
• If the appliance has been switched off or
disconnected from the power supply, it is
necessary to wait 5 minutes until switching
on again.
• No other appliances should be plugged into
the same socket as with this appliance.

Intended use

• This appliance is intended to be used for commercial
applications, for example in kitchens of restaurants,
canteens, hospital and in commercial enterprises such as
bakeries, butcheries, etc., but not for continuous mass
production of food.
8
foam blowing agent
propellant, flammable
• The appliance is designed only for making ice cubes. Any
other use may lead to damage of the appliance or personal
injury.
• Operating the appliance for any other purpose shall be
deemed a misuse of the device. The user shall be solely liable
for improper use of the device.
used is

Grounding installation

This appliance is classified as protection class I and must be
connected to a protective ground. Grounding reduces the risk
of electric shock by providing an escape wire for the electric
current.
This appliance is fitted with a power cord with grounding plug
or electrical connections with grounding wire. The
connections must be properly installed and grounded.

Control panel

(Fig.1 on page 3)
1: Water level is too low
2: Storage tank is full
3, 4, 5: Size of ice cube (S - Small, M - medium, L - Large)
6: Select the size of ice 7:
Power ON/OFF button

Preparation before use

• Remove all protective packaging and wrapping.
• Check that the device is in good condition and with all
accessories. In case of incomplete or damaged delivery,
please contact the supplier immediately. In this case, do not
use the device.
or
• Clean the accessories and the appliance before use (See ==>
Cleaning & Maintenance).
• Make sure the appliance is completely dry.
• Place the appliance on a horizontal, stable and heat resistant
surface that is safe against water splashes.
• Keep the packaging if you intend to store your appliance in
the future.
• Keep the user manual for future reference.
NOTE! Due to manufacturing residues, the appliance may emit
a light odor during the first few uses. This is normal and does
not indicate any defect or hazard. Make sure the appliance is
well ventilated.
Operating instructions
• Open the lid, remove the basket and fill the reservoir with water.
Do not fill beyond the level indicator. Make sure the basket is
above water.
• Press the "Power ON/OFF button" to start the process.
• Select the size of the ice cubes by pressing the "Select" button.
If the room temperature is bel ow 15°C, select "Small" or
"Medium" ice cubes to prevent the ice cubes from melting
together.
• The entire process of making ice cubes takes between 6 and 12.
GB