Polti QUICK&SLIDE QS210 Bedienungsanleitung Seite 11

digital display will stop flashing and remain
on: you can now begin ironing.
5. CONTINUOUS STEAM IRONING
Steam ironing is only possible when the
temperature is set to 3 or MAX (5). The
amount of steam can be adjusted with the
steam adjustment: when moved forward, the
amount of steam will increase, when moved
backward, it will decrease (3).
When first using the steam, there may
be some drops of water leaking out of
the soleplate. This is due to thermal
stabilization. It is recommended that the
first jets of steam are not directed onto the
fabric that needs ironing.
WARNING: When the temperature is set to
the levels 1 or 2, the steam (4) must be set
to the zero position (steam off/dry ironing)
otherwise water could leak out with the
steam.
6. STEAM JET
To make ironing faster and easier the STEAM
JET function can be activated, which is ideal
for removing the most stubborn wrinkles. To
activate it, press the button
Activate the Steam Jet every few seconds,
one after another.
If the display flashes while this function is
activated, wait until the symbol stops flashing
and remains on (the iron is at temperature
again).
WARNING: The STEAM JET function only
works when the temperature is set to the 3
or MAX level.
7. SPRAY FUNCTION
The Spray function is perfect for dampening
the entire surface of the fabric in a uniform
manner, making it easier to remove stubborn
wrinkles. To activate it, press the button
9).
8. VERTICAL IRONING
The iron may be used in the vertical position
to remove creases from fabrics and/or to
refresh fabric fibres, eliminating any residual
odours. During vertical use, to activate the
release of steam press the steam boost button
(6-7).
9. AUTO SHUT-OFF FUNCTION
When the Polti Vaporella Quick&Slide is not
used, the Auto Shut-Off safety function
activates. The time before activation varies
based on the position of the iron and starts
from the last completed action:
Vertical position: around 8 minutes
Resting or horizontal position: around 1
minute.
When the Auto Shut-Off function is activated,
the
iron will go into stand-by.
To reactivate the device, simply move it.
M A X
Before ironing again, wait until the symbol
on display stops flashing and remains on (the
iron is at temperature again).
10. OUT OF WATER
When the device no longer dispenses steam,
it means that there is no water in the tank.
To begin using steam again, simply remove
the power supply from the electric socket and
fill the tank as described in chapter 1.
11. SELF CLEAN SYSTEM
The Polti Vaporella Quick&Slide Self Clean
system ensures removal of limescale, thus
(6-7).
guaranteeing a better supply of steam,
avoiding the leakage of dirt from holes in the
plate which can create stains.
Regularly run the Self Clean cycle to ensure
better performance and durability over time.
Perform the cycle whenever the Self Clean
light
hours of use).
In any case, it is possible to perform the
M A X
cleaning cycle at any time.
To
recommend the cleaning procedure be
performed once a month.
Before running the cleaning cycle, make sure
you have a large receptacle or bowl on hand
to collect the water, steam and limescale that
(8-
will come out from the iron during the process,
thus avoiding the wetting of the ironing board
or surface on which you are ironing.
How to perform the Self Clean limescale
cleaning cycle:
11.1
electric socket.
11.2 Set the steam adjustment to the zero
position (=steam OFF)
11.3 Fill the water tank as described in
Chapter 1.
| 11 |
light will flash on the display and the
turns on x (after approximately 36
ensure the best
Unplug the power supply cord from the
performance, we
(3).