Polti QUICK&SLIDE QS210 Bedienungsanleitung Seite 10

CORRECT USE OF THE PRODUCT
Polti Vaporella Quick&Slide is intended for
domestic use as a steam iron in accordance
with the descriptions
contained in this manual. Please read these
instructions carefully and keep them. If
this manual is lost, it can be consulted
and/or downloaded
www.polti.com.
POLTI S.p.A. reserves the right to make the
aesthetic, technical and construction changes
it deems necessary, without prior notice.
Before leaving our factory all our products are
rigorously tested. Therefore, Polti Vaporella
Quick&Slide may
residual water in the tank.
Only usage as detailed in this instruction
manual constitutes correct usage. Any other
use may damage the appliance and invalidate
the warranty.
WHICH WATER TO USE
Polti Vaporella Quick&Slide has been designed
to function with medium-hardness tap water
between 8°f and 20°f. If the tap water is very
hard, do not just use demineralised water but
a mix composed of 50% tap water and 50%
demineralised water which is widely available
to purchase.
Warning: check the hardness of the water at
the technical office at your local council or
the local water supplier.
Never use rain water or water containing
additives (e.g. starch, perfumes), perfumed
water or water produced by other domestic
appliances, water softeners and filter jugs.
Do not add chemical, natural, detergent, or
limescale removing substances, etc. Do not
use Polti Kalstop.
1. PREPARATION FOR USE
1.1 Open the tank door and fill the tank with
water, using the provided pitcher (1). Hold the
iron at a slight angle and do not exceed the
MAX level indicator.
This step must always be carried out with the
power cable disconnected from the mains.
1.2 Close the tank door and rest the iron
vertically on the rest heel.
2. BEFORE IRONING
Before ironing an item of clothing, always
check the symbols on its label which show the
manufacturer's instructions.
Choose the most appropriate type of ironing
based on the following table:
and instructions
from the website
already contain some
High temperature – cotton, linen:
Set the iron temperature level to the •••
position.
Medium temperature – wool, silk:
Set the iron temperature level to the •• position.
Do not use steam.
Low temperature – synthetic, acrylic, nylon,
polyester:
Set the iron temperature level to the • position.
Do not use steam.
- Do not iron
- Steam ironing and steam treatment not al-
lowed
Divide the laundry
symbols on the garment labels or according
to the kind of fabric. Always start ironing
with the garments that require the lowest
temperature, in order to reduce the waiting
times and avoid the risk of burning the
fabrics.
3. DIAL AND TEMPERATURE
ADJUSTMENT
Thanks to the dial found on the handle of the
iron, you can easily select from the 4 different
temperature levels which will appear on the
digital display based on the fabric to be
ironed, as in the table below:
Level 1
Level 2
Level 3
Level MAX
M A X
To select the proper temperature, simply turn
the dial - right increases the temperature and
left decreases it (4).
4. IRONING
4.1 Ensure that the instructions in Chapters 1
and 3 have been followed.
4.2 Connect the cable plug to an earthed
power supply of the correct voltage.
4.3 Use the dial (2) to adjust the iron
temperature as in chapters 2-3.
4.4 The selected temperature level shown on
the digital display will begin to flash, indicating
the iron is heating up. When the iron reaches
the selected temperature, the icon on the
| 10 |
according to the