Lux Tools E-MUS-21 Originalbetriebsanleitung Seite 24

GB
Switching on/off
– Switching on: Set the On/Off switch (1) to posi-
tion [1].
– Switching off: Set the On/Off switch (1) to posi-
tion [0].
Sanding
DANGER! Risk of death through electric
shock! Only use the product for dry sand-
ing.
Note: Excessive imprints do not lead to
increased sanding performance, but leads
to increased wear of the product and the
sanding disc.
Note: Always work with the entire surface of
the sanding plate, not just the tip.
Note: When working vertical surfaces, hold
the device in such a manner that the dust
sack faces downward.
– Clamp in the workpiece or hold it firmly.
– Switch on the product and press it against the sur-
face to be sanded applying even pressure.
– Always use constant motion and only use light
pressure.
Cleaning
DANGER! Risk of injury! Before all work
on the device, disconnect the mains plug.
Cleaning at a glance
Regularly, depending on the conditions of use
What?
Clean dust from the mo-
tor's ventilation slots.
Fault/malfunction
Product not running.
Sanding power too low.
If you can't fix the fault yourself, contact your nearest
vendor. Please be aware that any improper repairs
will also invalidate the warranty and additional costs
may be incurred.
Disposal
Disposal of the appliance
A crossed-out wheelie bin icon means: Bat-
teries and rechargeable batteries, electrical
or electronic devices must not be disposed of
with household waste. They may contain
substances that are harmful to the environ-
ment and human health.
Consumers must dispose of waste electrical devices,
spent portable batteries and rechargeable batteries
separately from household waste at an official collec-
tion point to ensure that these items are processed
24
How?
Use a vacuum cleaner,
brush or paintbrush.
Cause
Device defective?
Is the sanding disc not suitable for
material?
Sanding disc worn out?
What?
Clean the device.
Empty the dust container
Note: Always empty the dust collector to
ensure optimum dust collection.
► P. 3, fig. 2
– Pull the dust collector (2) fully away from the rear
of the device.
► P. 4, fig. 3
– Press the unlock push butons (5) and keep them
pressed.
– Remove the lid (6) from the dust collector.
► P. 4, fig. 4
– Remove the filter mat (7).
– Empty the dust container.
– Re-install the dust container in reverse order. Pay
attention to the correct position of the filter mat.
Troubleshooting
If something doesn't work...
DANGER! Risk of injury! Improper repairs
can result in the product functioning
unsafely. This endangers yourself and your
environment.
Malfunctions are often caused by minor faults. You
can easily remedy most of these yourself. Please
consult the following table before contacting the ven-
dor. You will save yourself a lot of trouble and possibly
money too.
Remedy
Contact your local vendor.
Replace the sanding disc (► Attach
the sanding disc – p. 23).
correctly. The product can be returned free of charge
in accordance with the legal requirements, for exam-
ple through a municipal waste disposal company or a
dealer.
Batteries, rechargeable batteries and lamps
that are not permanently installed in waste
electrical equipment and can be removed in
a non-destructive way must be removed and
disposed of separately before disposal of the equip-
ment. Lithium batteries and rechargeable battery
packs of all systems are only to be handed in to the
waste collection points in a discharged state. The bat-
teries must always be protected against short circuits
by taping off the poles.
All end users are responsible for deleting any per-
sonal data stored on waste devices prior to their dis-
posal.
How?
Wipe the device with a
slightly damp cloth.