INTEZZE CLIQ Bedienungsanleitung Seite 3

EN
First pairing of the earbuds
Before you begin using the earbuds, remove the protective film from the
charging pins and then put the earbuds back in the case. Remove both earbuds
from the case and wait for about 3 seconds before pairing mode is activated
(both earbuds will flash blue). Select "Intezze CLIQ" from the available BT devices
on your phone and confirm connect. After successful pairing you´ll hear a
confirmation message "Connected". If the earphones don't flash when you take
them out of the case, put them back in the case and charge them with the
included USB-C cable.
Powering ON / OFF
Power ON
Method 1: Take out the earphones from the charging case, the earphones will
switch on automatically.
Method 2: In the off state, press and hold the touch area on both earphones for
3 seconds. The earphones will turn on and you can hear the prompt "Intezze on".
Power OFF
Method 1: Put the earphones into the charging box. They will shut down
automatically, but not if the charging case runs out of battery.
Method 2: Turn off your phone's Bluetooth and the earphones will
automatically shut down in 3 minutes.
Method 3: Turn off your phone's Bluetooth and hold the touch area on both
earbuds for 4 seconds until you hear "Intezze off".
3