eta CRYSTEN Bedienungsanleitung Seite 16

EN
• The producer is not responsible for damage caused by improper use of the appliance
(e.g. burning, scalding, fire) and does not apply in the case of non–compliance with the
safety instructions above.
II. DESCRIPTION OF THE APPLIANCE (FIG. 1)
A – electric kettle
A1 – off/on button 0/I (steam sensor switch*)
A2 – control light
A3 – water gauge
A4 – handle
B – removable stand
B1 – central connector
* The steam sensor ensures automatic switch off the appliance after reaching the boiling point.
III. INSTRUCTIONS FOR USE
Fill the kettle with clean cold water up to max., turn it on and let the water boil before first
use. Then Pour the water out and repeat the process several times (at least five times).
USE
Unwind the necessary length of the power cord B2 from the storage space of the stand B.
Place the stand on a suitable surface, in the height of about 85 cm, out of reach of children
and incapacitated persons and plug the fork of the power cord to the electric socket. Hold
the kettle A on the handle A4. Open the lid A5 by pressing the lock button A6. Fill the
kettle with drinking water. The minimum and maximum amount of water is marked on the
water gauge A3. Close the lid by snapping and position the kettle filled with water onto the
removable base B. Put the electric kettle on the stand and turn it to the I position by the A1
button. Function of the electric kettle is signaled with the control light A2. After boiling the
appliance switches off automatically. Before reaching the boiling point, you can switch off
the appliance by turning the A1 button to the 0 position. Always use fresh drinking water for
boiling.
• When heating water, the lid must be closed, otherwise the kettle will not turn OFF.
• If the kettle was removed from the stand during boiling, remains in ON position. This
means that if you put it back on the stand, it will immediately continue in heating.
• Make sure the sieve is fit on thorougly in the upper part of the kettle in order that it
does not fall to the bottom!
• In bigger tilting of the electric kettle backwards, particularly when it is filled up to
maximum, water can flow out from the electric kettle in the bottom part of the kettle.
This does not affect safety or other functions and it does not mean any failure of the
electric kettle. In the case of tilting the electric kettle with hot water there is a risk of
scalding. Therefore do not tilt the electric kettle.
• Recommendation: When the kettle is not used, do not place it on the stand connected
to the mains. If you are going not to use the kettle for a long time, unplug the power
cord from the wall socket.
A5 – lid
A6 – lid lock button
A7 – filtration sieve
B2 – power cord
ATTENTION
EN - 16