cecotec POWERGYRO 3500 ANGLE SET Bedienungsanleitung Seite 150

ENGLISH
Problem
The first time you
start the machine
there is smoke and a
slight smell
The battery does not
charge
The appliance does
not work
Unusual noise
Information
– Wait for at least 10 minutes before restarting the device after every maintenance and
repairing work.
– If the device is not working properly, contact the official Cecotec Technical Support Service.
6. TECHNICAL SPECIFICATIONS
Product: 00186 / A01_EU01_100100
Product reference: PowerGyro 3500 Angle Set / PowerGyro 3500 X-treme Set
Nominal speed: 200 rpm
150
POWERGYRO 3500 ANGLE SET
POWERGYRO 3500 X-TREME SET
Possible solutions
It is not a fault. Shortly after we start the machine, both the smoke
and the smell will disappear.
Check the cable connection is correct and it is not damaged. If you
notice any damage, stop using the appliance. Contact the official
Cecotec Technical Support Service.
You must check there is no dirt in the cord connections. Clean the
dirt.
Check that there is power at the base of the socket.
Check both the cord and the power plug are not damaged.
Check the power supply (fuses, thermal-magnetic circuit breakers,
RCDs, etc.).
The battery may be defective or damaged. Contact the official
Cecotec Technical Support Service.
The battery level may be too low. Charge the battery.
The USB cable connectors can be dirty. Clean them by removing the
dirt remains.
If the machine still does not work, contact the official Cecotec
Technical Support Service.
Torque value exceeded (protection against tool overload or
damage to the bolt/bolt head).