Herunterladen Diese Seite drucken

cecotec POWERGYRO 3500 ANGLE SET Bedienungsanleitung Seite 147

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 43
Warning
Do not substitute bits without placing the lock/rotating direction knob (9) in the central
position.
Heads assembling/substitution
The screwdriver has a head removal button (13) for locking/unlocking the heads. First, set
the lock/rotating direction knob (9) to the central locking position.
To remove the head, press the two head removal buttons (13) at the same time, then
remove the head.
To replace the head, insert the head and ensure that it is correctly installed before use. It
must fit in place.
The 90º screwing head (4) and the eccentric head for corners (15) will allow you to work
near edges, walls and difficult to access places.
Warning
Do not substitute heads without first placing the lock/rotating knob (9) in its central locking
position.
Turning the screwdriver on and off
It is recommended to use personal protective equipment during the screwdriver use.
To turn on the tool:
1.
Make sure the battery is charged.
2. Assemble the bit.
3. Pull the trigger (8).
To turn off the tool, release the trigger (8).
LED work light
The screwdriver has two built-in LED work lights to illuminate the workspace.
By pulling the trigger (8) the front LED work lights will turn on (10).
4. CLEANING AND MAINTENANCE
Maintenance
You must store lithium ion batteries completely discharged. You may cause a total
discharge and, as a result, it may break.
While the device is not being used, you must store it following these instructions:
The room temperature must be lower than 40 ºC.
It must be dry, moisture-free and protected from cold and heat.
You must store it in a place protected from dust and direct sunlight.
POWERGYRO 3500 ANGLE SET
POWERGYRO 3500 X-TREME SET
ENGLISH
147

Werbung

loading