Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ENGLISH
–
Do not use the appliance while the battery is charging.
–
A new battery will develop its full ampere-hour capacity after 5 complete charge/discharge
cycles.
The screwdriver has a battery level indicator light (14). The three LEDs, each of a different
colour, indicate the battery charge level. To check the level:
–
Set the lock/rotating direction knob (9) to the desired position, except the locking position.
–
Pull the trigger (8). The LEDs will turn on, indicating the battery level.
–
Fully charged battery: three indicator lights on.
–
Low battery: two indicator lights on.
–
Uncharged battery: one indicator light on.
To charge the battery
–
Connect the end of the micro USB cable (6) from the power adapter (5) to the micro USB
input (7) in the tool. Connect the power adapter (5) to a mains power socket. The LED
indicator lights (14) will turn on.
–
After charging, when all LEDs (14) are illuminated, unplug the tool cable and the power
adapter.
Warning due to electrical voltage
Do not ever touch the plug with your hands wet.
When you have finished using the device:
1.
Unplug the device.
2. Unplug the USB cable by pulling the connector, not the cable.
3. You must leave the device to cool down (if necessary).
4. Clean the device. Read the "Cleaning and maintenance" section.
5. You must store the device following the "Storage" section.
Selection of the rotation direction Fig. 2
Use the lock/rotating direction knob (9) to set the rotating direction clockwise or
counterclockwise, or place it in the centre to lock the tool.
Warning
Do not try to change the direction while pulling the trigger (8) or while the shaft rotates.
Bits assembling/substitution
–
The screwdriver is equipped with a bit holder (12). Set the lock/rotating direction knob (9)
to the central locking position.
–
Tighten the bit to the bit holder (12). Check the bit assembling.
–
To remove the bit, pull it.
146
POWERGYRO 3500 ANGLE SET
POWERGYRO 3500 X-TREME SET
Werbung
