cecotec POWERGYRO 3500 ANGLE SET Bedienungsanleitung Seite 145

- 90º head
- Power cable and adapter
- Carrying case
- Instruction manual
Box content for reference A01_EU01_100100 - PowerGyro 3500 X-treme Set:
- Screwdriver
- Set of 10 bits
- Extension
- Eccentric head for corners
- Power cable and adapter
- Carrying case
- Instruction manual
Note
Dispose of packaging materials according to national regulations. To avoid damages, handle
the device properly.
Warning due to electrical voltage
Electric shock due to inadequate or insufficient insulation. Check, before using it, that the
device and its accessories are not damaged and work properly. If you detect any damage do
not switch it on. Do not use the equipment if it or your hands are wet!
3. OPERATION
– Always choose the appropriate bit for the screw to be used. To avoid damaging the screw,
use the largest possible bit size to fit the screw head.
– The screwdriver has two built-in LED work lights (10) to illuminate the workspace.
Charging the battery
Warning
– During the charging process the handle may heat up, it is normal.
– If the battery charges improperly, it could get damaged. Do not ever charge the battery in a
room temperature below 10 ºC or over 40 ºC.
– The battery is supplied half-charged to prevent damage due to total discharge.
– The battery must be fully charged before using the device for the first time and whenever
the battery level is low. The red light in the battery level indicator light informs of a low
battery level.
POWERGYRO 3500 ANGLE SET
POWERGYRO 3500 X-TREME SET
ENGLISH
145