Zeegma Zonder Pro Aqua Bedienungsanleitung Seite 11

TROUBLESHOOTING
Problem Cause
An unpleasant •
odour is
coming from •
the vacuum
cleaner.
The pump is •
not supplying
water with •
detergent.
The vacuum •
cleaner has
insufficient •
suction power.
The pump •
makes noise.
The vacuum •
cleaner is not
working.
CLEANING AND MAINTENANCE
Important! When cleaning fabrics or handling wet surfaces, the vacuum cleaner takes in very
little air, which reduces its cooling performance. Monitor the temperature of the appliance
and take regular breaks.
1.
After using the appliance, make sure to rinse both the suction hose and the water and
detergent dispensing hose.
2.
To do this, start by emptying and rinsing the tank for clean water and detergent. Next,
pour 0.5 litre of clean water into the tank, attach it to the vacuum cleaner, switch on the
pump, and allow clean water to flow through the hose. It is important to do this with
the suction nozzle installed and the tubes previously used to rinse the spray nozzle.
3.
To rinse the suction hose, pour 2 litres of clean water into clean bucket, turn on the
vacuum cleaner and suck it in using the tube with the previously used suction nozzle
and tubes to rinse them out.
4.
Switch off and disconnect the appliance from the power supply.
5.
Detach the clamps to remove the clean water tank.
6.
Remove and rinse the sponge filter. Allow it to dry completely. The sponge filter is reusable.
7.
Wipe the inside of the tank with damp cloth and let it dry completely.
The photos are for reference only; the actual appearance of products may differ from the photos.
The appliance has not
been sufficiently cleaned.
The filter has been used
beyond its recommended
service life.
The accessories are not
fitted correctly.
The spray nozzle is
clogged.
The appliance has not
been sufficiently cleaned.
The filter has been used
beyond its recommended
service life.
There is no water in the
clean water tank.
There is no power supply.
Solution
• Clean the dirt tank and the suction tube.
• Inspect the condition of the sponge filter.
• Stop using the vacuum cleaner
temporarily.
• Check to make sure that the spray nozzle
and the strainer at the beginning of the
detergent supply line in the clean water
tank are free from dirt and blockages.
• Clean the spray nozzle.
• Inspect the condition of the dry vacuum
cleaning bag.
• Unblock the flexible hose/suction tube.
• Clean the sponge filter.
• Check the level of clean water in the tank
and top up if there is not enough.
• Check to ensure that the appliance is
properly connected to the power source.
EN