Zeegma Zonder Pro Aqua Bedienungsanleitung Seite 10

7.
To attach the extension hose (9, Fig. A), secure it to the flexible suction hose with spray
EN
tube (1, Fig. A). Ensure that it is firmly secured. To remove the extension hose, pull it out.
CLEANING OF UPHOLSTERY AND CARPETS
Important! After each use of the appliance, make sure to rinse both the clean and dirty water
tanks, along with the suction hose and the spray tube with nozzles.
1.
To use the vacuum cleaner for cleaning upholstery and carpets, place the sponge filter
on the filter support (Fig. 4). Remove the HEPA filter before use (see: REMOVAL OF
DRY DIRT AND DEBRIS, step 7).
Important! When wet cleaning, always use sponge filter.
2.
Fill the clean water tank (10, Fig. A) with the prepared water and detergent solution,
then attach it to the back of the appliance (Fig. 6). Ensure that it is securely connected.
Important! The amount of clean water in the tank should not exceed 4 litres. For better
cleaning efficiency, it is recommended to use warm water up to 40°C.
3.
Connect the flexible suction hose to the outlet opening (7, Fig. A) and the spray tube to the
spray tube connection (6, Fig. A). Affix an appropriate attachment (Fig. 9). Ensure it has been
installed correctly. To remove the attachment, press the release button (a, Fig. 8) and pull.
REMOVAL OF WET DIRT
1.
Connect the power cord to the power source and switch on the appliance using the
main switch (3, Fig. A).
2.
Use the vacuum cleaner to remove wet dirt from the surfaces to be cleaned. Repeat,
if necessary.
SURFACE SPRAYING
1.
Connect the power cord to the power source.
2.
To distribute the cleaning solution, press the pump switch (2, Fig. A) and the trigger on
the handle of the flexible suction hose with spray tube (Fig. 10).
SIMULTANEOUS SPRAYING AND VACUUM CLEANING
1.
Connect the power cord to the power source.
2.
Start the appliance with the main switch and press the pump switch. Then press the
trigger on the handle of the flexible suction hose with spray tube and secure it in position
using the locking mechanism (Fig. 11).
Important! Use suitable detergents according to the manufacturer's recommendations for
the surface being cleaned.
Important! Always move the cleaning nozzle towards yourself along the surface being cleaned.
Important! If the tank overflows, the float obstructs the suction opening, resulting in an
increased speed of the suction turbine. Immediately switch off the appliance, disconnect it
from the power source, and empty the tank. Switch off the appliance by pressing the switch
(3, Fig. A) and the pump switch (2, Fig. A). To remove the clean water tank, simply pull it out.
If the appliance tips over with water inside, switch it off immediately and disconnect it from
the power source to prevent motor damage.