Atlas Copco ETB 4 Original-Produktanweisungen Seite 3

ETB
Notice
Many events in the operating environment may af-
fect the tightening process and shall require a vali-
dation of results. In compliance with applicable
standards and/or regulations, we hereby require
you to check the installed torque after any event
that can influence the tightening result. Examples
of such events include but are not limited to:
• initial installation of the tooling system
• change of part batch, bolt, screw batch, tool,
software, configuration or environment
• change of air- or electrical connections
• change in line ergonomics, process, quality
procedures or practices
• changing of operator
• any other change that influences the result of
the tightening process
The check should:
• Ensure that the joint conditions have not
changed due to events of influence.
• Be done after initial installation, maintenance
or repair of the equipment.
• Occur at least once per shift or at another suit-
able frequency.
Safety and operating
instructions
Safety instructions
Warning
Read and understand all instructions.
Failure to follow all instructions listed below, may
result in electric shock, fire and/or serious personal
injury.
Work Area
Keep your work area clean and well lit.
Cluttered benches and dark areas invite accidents.
Do not operate power tools in explosive atmos-
pheres, such as in the presence of flammable liq-
uids, gases, or dust.
Power tools create sparks which may ignite the
dust or fumes.
Keep bystanders, children, and visitors away while
operating a power tool.
© Atlas Copco Industrial Technique AB - 9836 1316 08
Distractions can cause you to lose control.
Keep tool dry.
Do not expose tool to rain. Do not use tool in
damp or wet locations.
Electrical Safety
• Damaged cords may create a fire. Never use
cord to carry the tool. Keep cord away from
heat, oil, sharp edges, or moving parts. Replace
damaged cords immediately.
Personal Safety
• Stay alert, watch what you are doing, and use
common sense when operating a power tool.
Do not use tool while tired or under the influ-
ence of drugs, alcohol, or medication.
• A moment of inattention while operating power
tools may result in serious personal injury.
• Dress properly. Do not wear loose clothing or
jewelry. Contain long hair. Keep your hair,
clothing, and gloves away from moving parts.
• Loose clothes, jewelry, or long hair can be
caught in moving parts.
• Avoid accidental starting. Be sure switch is in
the locked or off position before inserting bat-
tery pack.
• Carrying tools with your finger on the switch
or inserting the battery pack into a tool with the
switch on invites accidents.
• Remove adjusting keys or wrenches before
turning the tool on.
• A wrench or a key that is left attached to a ro-
tating part of the tool may result in personal in-
jury.
• Do not overreach. Keep proper footing and bal-
ance at all times.
• Proper footing and balance enable better con-
trol of the tool in unexpected situations.
• Use safety equipment. Always wear eye protec-
tion.
• Dust mask, non-skid safety shoes, hard hat, or
hearing protection must be used for appropriate
conditions.
Tool Use and Care
Use clamps or other practical way to secure and
support the workpiece to a stable platform.
Safety Information
3