Chapter 9 How To Clean - Fretta Boost Bedienungsanleitung

Chapter 9 HOW TO CLEAN

It's important to keep your juicer clean to ensure its long life. Switch off the juicer
and unplug. Wash all parts with warm soapy water. If the mesh on the juicer jug is
clogged with pulp, use the supplied cleaning brush.
Please note:
• Do not use an iron wire brush to clean.
• If you use the dishwasher, It is important to not wash above temperatures of 40℃.
When washing the bowl, remove the silicone valve
from the socket. This will make it easier to clean.
When putting the seal ring back in, the small ribbed
surface should at the bottom/outside the bowl. The
flat side should be inside the bowl.
When cleaning the base, never submerge it under water. Simply wipe it clean using
with a damp cloth.
After cleaning, please make sure all parts are fully dry before reassembling.
www.iFretta.com / www.fretta.co.uk
Lift the bowl from the base.
Immediately clean the juicer after each
use. If remaining residue in the juicer
4
dries up, it can make disassembling and
clean-up difficult. The excess build up
can cause poor performance in future
uses.
Clean the seal ring of the bowl by turning the bowl upside
down and pushing the ring out with your thumb.
7
E-mail:support@fretta.net