Chapter 10 Troubleshooting - Fretta Boost Bedienungsanleitung

Chapter 10 TROUBLESHOOTING

Q1 When there is no power to the juicer:
•Check if the power cord is properly plugged into the plug socket (and the plug
socket is turned on).
•Check if the drum lid and the juicing bowl are properly assembled. Watch Chap-
ter5 - how to assemble! It won't turn on if assembled incorrectly.
•If the juicer stops due to the overload protection, let the juicer cool before juicing
again.
Q2 Low juice yield:
•Different ingredients hold different amounts of fluid that will yield different amounts
of juice. If the ingredients are not fresh, they may contain reduced amounts of fluid.
which will yield less juice.
•Check if the silicone valve lip is firmly inserted into the bowl to ensure no juice is
leaking.
•If the ingredients have low water content, it may help to soak them in water before
juicing. If juicing ingredients with small seeds, the yield may reduce due to seed
residue.
•For certain fruit, disassemble and wash the top-set in between juicing. If there is
seed residue on the bottom of the auger, this can affect juicer performance and the
overall juice yield.
Q3 There is too much pulp in the juice:
•When continuously juicing, depending on the ingredients, the juice may contain a
lot of fine pulp. To reduce the fine pulp, clean the juice jug frequently.
•Use an external sieve and put the juice through it to collect the unwanted pulp.
•If the juice jug and the auger are damaged and affecting the juicer's performance,
it is recommended the parts be replaced. The lifetime of each part may vary
depending on length and method of use and ingredients extracted.
8
www.iFretta.com / www.fretta.co.uk E-mail:support@fretta.net