Eliminating Minor Faults Yourself - Siemens KG39FSB30/19 Gebrauchsanleitung

Eliminating minor faults yourself

Before you call customer service:
Please check whether you can eliminate the fault yourself based on the following
information.
Customer service will charge you for advice – even if the appliance is still under
guarantee!
Fault
Temperature differs greatly
from the set value.
The light does not work.
Displays do not illuminate.
Floor of the refrigerator
compartment is wet.
Possible cause
The LED light is defective.
Light switch is jammed.
Power failure; the fuse has
been switched off; the mains
plug has not been inserted
properly.
The condensation channels
or condensation drainage
pipe are blocked.
Stopper is missing from
the condensation drainage
pipe.
Remedial action
In some cases it is adequate to switch off
the appliance for 5 minutes.
If the temperature is too high wait a few hours
and check whether the temperature has
approached the set value.
If the temperature is too low check
the temperature again the next day.
See chapter "Light (LED)" section.
Check whether the light switch can move.
Connect mains plug. Check whether the power
is on, check the fuses.
Clean the condensation channels
and the outlet (see "Cleaning the appliance").
Fig. ,
Insert stopper.
en
41