Werbung
Verfügbare Sprachen
Verfügbare Sprachen
• Place the tile cutter on a flat, level and non-slip surface.
• Fill the bowl with water until the cutting disk is covered with water. Never use the tile
cutter without water!
• Set the on/off switch to "Off" and plug the mains cable into the socket.
• Switch on the tile cutter and wait a few seconds until the cutting disc has reached its
maximum speed and make sure that the cutting disc is wet.
• Now slide the tile slowly along the guide rail to the cutting disk. The cutting blade
guard slides up automatically, as shown in Fig. 8.
• When the tile has been cut, switch off the appliance. Please note that the cutting disc
does not stop immediately after the tile cutter is switched off, but continues to run for a
short time!
• To perform a mitre cut, loosen both adjustment knobs and tilt the tabletop to the
desired angle (e.g. 45°). Then screw the adjustment knobs back on.
Avoid hand contact with the blade while the machine is in operation. It can
cause serious injuries to the hand
16
Operation
Figure 8
V. 1.0
EN
Werbung
