Panasonic CZ-RWSU3 Kurzanleitung Seite 5

Receiver
CZ-RWSU3 CZ-RWSU2N
3 4 5
1
1
2
CZ-RWSL2N
3 4 5 Display
Operation Panel
7
1. Receiver
Receives the signal sent from the remote
controller.
2. Emergency operation button
Indicator lamps
When an error occurs, one of the lamps
flashes. When an indicator lamp is flashing,
refer to "Before Requesting Service".
3. OPERATION lamp
Lights up when the unit is operating.
4. TIMER lamp
Lights up when the timer is set.
5. STANDBY lamp
• The lamp in the HEAT mode lights up at
the following times: during the startup,
during the thermostat operation, and
during the defrosting.
• The lamp flashes when an error occurs.
6. FILTER lamp
This lamp is for notifying you when the filter
needs to be cleaned.
CZ-RWSD2
2
2
3
4
5
3 4
CZ-RWST3N
2
1
3 4 5
2
CZ-RWSK2 (For wall mounted type indoor unit)
OPERATION TIMER
STANDBY
CZ-RWSC3
ADDRESS 1
ADDRESS 2
ADDRESS 3
REM SUB/MAIN
5 1
1
2
3
4
5
6
Front side
1
3
4
1
2
5
7. Address switch
Used to set the remote controller
addresses. (Refer to the installation
instructions for details of the address
setting switch.)
Note
• If non-cooling/heating free type is being
used, it will beep twice and the operating
lamp will light up on the display; if the timer
and standby lamps blink alternately, a
confl ict between the heating and cooling
exists, so the unit cannot operate in the
desired mode. (On models that do not have
an Auto function, even if Auto is selected, it
works in the same way.)
• When the local operation is disabled by
centralized control or similar cause, and if
the Start/Stop , Mode
setting button
will beep fi ve times and the change will not
be made.
1 2 3 4
Rear side
2
3
4
5
or Temperature
is pressed, the unit
7
5