Panasonic EH-XT20 Bedienungsanleitung Seite 19

5
5
Hold the main body firmly
touching the microcurrent panel
(a) on the rear of the main body.
• When the titanium head is applied to
the skin in this state, the titanium head
detects the skin and vibrates.
(See page 17.)
• If the titanium head is applied to the
skin immediately after selecting the
microcurrent or temperature level, the
lamp display will switch to mode
function display even before 5 seconds
have passed.
6
6
Move the titanium head while touching the skin.
PURIFYING mode
MOISTURIZING mode
AUTO mode
• The power will be automatically turned off after each mode
is completed.
• You can also turn it off by a long press of the POWER/
SELECT switch.
If using a cotton pad, please remove it.
• Do not reuse the used cotton pad.
Doing so may result in skin discomfort.

(See page 20.)
(See page 20.)
(See pages 20 and 21.)
When using COOLING mode
• Skin care products, cotton pads and cotton rings are not required.
1
1
Press the switch and select
COOLING mode.
• Each press switches to the next
mode. (See page 18.)
2
2
Move the titanium head while touching the skin.
(See page 21.)
Notes
• Avoid continuous use.
• The titanium head does not vibrate. (See page 17.)
• The fan operates.
Do not block the air inlet (a) or air outlet (b).
• 2 minutes after selecting the mode, the power
automatically turns off. (The fan also stops.)
• To turn off the power during use, please press
and hold the POWER/SELECT switch.
• The titanium head temperature depends on
the ambient temperature. Please use the
appliance in an ambient temperature range of
15 ˚C to 35 ˚C.


19