Werbung
Verfügbare Sprachen
Verfügbare Sprachen
IMPORTANT
NOTES
If you wish to use the instrument with external AC Adaptor, use only type Boss ACA (optional) and
follow these precautions:
The appropriate power supply for the instrument (100, 120, 220 or 240 V) is shown on the AC ADAP-
TOR name plate. Please make sure that the line voltage in your country meets the requirements.
Please do not use the same socket used for any noise generating device (such as a motor, variable
lighting system).
* It is normal for this unit to become hot while being operated.
If the unit is not to be used for a long period of time, unplug the external AC Adaptor from the AC line.
Disconnected the AC Adaptor immediately in the event of an electrical storm.
Before setting up this keyboardwith other MIDI devices,turn this köyboardoff alongwith all other
units.
Be sure to connect the MIDI cable securely. If the MIDI cable is disconnected while the instrument
is being played, various troubles will occur (e.g. the note may continue to sound).
Static electricity may cause the built-in computer to malfunction. Should this occur, simply reset the
instrument by turning the power switch off and then after a few seconds, back on.
This instrument might not operate correctly if turned on immediately after being turned off. If this
happens, simply turn it off and after a few seconds later, turn it on again.
* Operatingthe'PC-200neara neonlight, fluorescentlamp,TV or CRT display,maycausenoiseinter-
ference. If so, change the position of the instrument.
* To avoid risk of electric shock, do not perform any servicing. Refer all servicing to qualified service
personnel.
THE
CARE
OF
YOUR
To ensurethe best useand frill enjoyment of your PC-200,pleaseread this guide carefully and thoroughly.
ROOM
LOCATION
Avoid using this instrument in excessive heat or humidity conditions or where it may be affected by
direct sunlight or dust and avoid places subject to high vibrations.
CABINET
CARE
Use a soft dry cloth for dusting. To remove fingerprints or dulling film, use a soft cloth slightly damp-
ened with water and a little mild detergent. Immediately wipe dry with a soft cloth. Do not use solvents
such as paint thinners.
OPERATION
After having inserted the six batteries into the appropriate holder, press the power On/Off switch [9]
to operate the PC-200.
To use the PC-200 with the AC Adaptor (optional), connect the AC Adaptor to the 9 Volts DC IN socket
[10], located on the rear panel of the instrument.
Make sure that the line voltage in your country meets the requirements. Connect the AC Adaptor to
AC line. Press the power on/off switch [9] to activate the instrument.
PC-200
7
Werbung
